1. Stripping and trimming effect. It is necessary to carefully observe whether the wire after stripping of the automatic terminal machine will be stripped, the stripping is not aligned, the copper wire is damaged, the outer skin is scratched, and the wire has obvious twists and turns. Not the same length and so on. Of course, the length of the stripping and cutting length has an error value of 0.2 mm + (set length × 0.002 mm).

 

2, the effect of crimping the terminal, the quality of a fully automatic terminal machine is mainly depends on the effect of its crimping terminal, if the terminal it is crimped is defective, or does not overwhelm the copper wire, or the pressure interface is Loose, it will directly affect the quality of your product. This will be a fatal injury.

3, the speed of the automatic terminal machine, if the above two points are almost the same, the working speed of the automatic terminal machine will be its other secondary indicators. The enterprise chooses the automatic terminal machine mainly for its automation. If its speed is higher, it means that it will bring you higher efficiency. Of course, the premise is that the wire harness processed by the fully automatic terminal machine is a good product. .