When using the terminal machine for production and processing, the use of the tool is very important. If the thickness and size of the wire are different, the blade of the terminal machine needs to be changed, which is very simple; and the die of the terminal machine is mainly processed by different types. For wire, different types of molds are used.

 

1. Disassembly and installation of the mold:

 

Case 1, if you want to delete the mold, you should first adjust the machine to manual mode, press the "down" or "down" punch, when you see the high-end die rotate the mold lock lock counterclockwise, pull, keep the lock The mold is then pushed horizontally to the left.

 

Case 2: If you plan to install the mold, you should first remove the mold lock, the level of the mold is then pushed to the right, and punching into the top of the mold is enough (if the punch has sunk, move the hand tool inside the mold gate) Ascending will require a too high or too low punch, adjustable in manual mode to the appropriate height), then into the mold fixing fixture and tighten the clockwise rotation.

 

2, the installation method of the upper and lower blades:

 

The terminal machine is equipped with 2 knives (upper boring tool) and 2 knives (lower knives), or some specific terminal machine dies have only one knives.

 

3. The mold filling terminal to be put into use:

 

The adjustment of the terminal machine blade has been completed, the terminal can be placed in the mold, the front needs to be placed on the frame, fixed by the guide plate cutter, and the circuit terminal.

 

4. At the end position of the drive pin and the hole cover:

 

Pull out the "drive pin fixing screw" so that the "drive pin and hole cover" and the only insert material can have holes just in the terminal, then the lock drive pin fixes the middle of the screw. Will go to "end back eccentric", then go to manual mode will go to the head to adjust to low, the terminal position is lower than it, if not below the need to tighten the "screw fixing screw", then turn "driver needle adjustment" by hand The screw is used to observe the tightness, so that the terminal is lower than the die, and the fixing screw for locking the screw can be used. Then you need to adjust the hole cover hole with the material such as the next block and the hole cover.

 

Steps for replacing the blade with the automatic terminal machine:

 

1. Unplug the mechanical equipment and let the terminal machine stop.

 

2. Locate the appropriate screwdriver to loosen the place where the blade is fixed.

 

3. Take the blade down and replace it with another blade;

 

4, according to the original steps to install directly on the line.