For machines, poor contact has always been one of the main causes of failure, from small mobile phones to computers, to terminal machines, or to aviation equipment. For the computer, the fault of the contact is more than the memory stick.
 

For the automatic terminal machine, the poor contact is the metal conductor inside the terminal, which is the core zero of the terminal, which transmits the voltage, current or signal from the external wire or cable to the matching connector. On the contact piece. Because of its importance, we have a very high demand for it, which requires stable and reliable contact and good electrical conductivity.
 

For wire harness equipment such as single-head terminal machines, enterprises should consider the following factors when purchasing a silent terminal machine: the quality of the single-head terminal machine is good and the performance is stable. The high-precision, multi-functional, high-quality automation equipment is stable during use; the single-head terminal machine has a long service life, and after the mechanical equipment enters the production line, it will wear out after a long period of operation.
 

The length of the peeling opening of the fully automatic crimping machine is different: there are many common reasons for the different opening, such as the feeding roller is too tight or loose; in this case, you only need to use the roller fine adjustment to adjust the gap between the two wheels. So that the wire is not flattened and too slippery. If it is because the cutting knife is too shallow or too deep; then we use the cutter depth adjustment member to adjust the knife edge to the appropriate position, so as not to damage the copper wire and can peel off the rubber. If the opening is still different, replace the new cutting blade directly.
 

The surface quality of the part includes the surface roughness, the degree of hardening of the surface layer and the nature and size of the surface residual stress. The surface quality of the part has the properties of wear resistance, corrosion resistance, fatigue resistance, and the service life of the part. Great impact. Therefore, the surface quality requirements of parts working under high speed and heavy load are high, and the requirements of surface roughness are only indicated on the drawings of general parts. The arithmetic mean deviation of the contours of the surface roughness.