Ultra-quiet terminal machine has low noise, low power consumption, accurate feeding and high efficiency.

 

Check if the tool matches the terminal. After proper adjustment, the following standards should be met:

 

1. After crimping, the tensile force of the pressure line and the tensile force of the rubber should meet the tensile strength standard;

2. After crimping, the shrapnel remains in its original shape;

3. There should be a bell mouth on the side of the terminal crimping line, which does not allow the occurrence of undesirable phenomena such as flying silk and rubber pressing;

4. There is no deformation of the terminal after crimping.

Ultra-quiet terminal machine

step:

1. Confirm the line card indication, whether the terminal/mold confirms that it meets the requirements;

2. Start the ultra-quiet terminal machine and stop it after the operation, with the knife, mold, and knife;

3. Install the mold frame with the tool on the ultra-quiet terminal machine and clamp it with the clamp. At this time, use the manual adjustment knife to move the ultra-quiet terminal machine slider to the bottom dead center, loosen the screw of the clamping tool, adjust Appropriate position of the tool, and then tighten; at this time pay attention to the pressure of the crimping, and pay attention to the cooperation between the upper knife and the lower knife, so as to avoid the left and right offset of the tool;

4. Test the terminal and the line, see the crimping condition, and then make the tensile test. If the technical requirements are not met, adjust the pressure screw on the ultra-quiet terminal machine to meet the requirements and lock it;

5, then use manual pressure test, so as not to hit the knife when crimping, electric operation to see if the crimping machine and the mold have different noise or impact sound, check the blade feeding device and its stroke;

6. After no abnormality in idling, the test pressure of 2-3pcs is tested by the first inspection of the inspection, and it can be produced after passing the test;

7. When crimping, take the line and feed line with the left hand, and send the line and position with the right hand. Place the line on the lower blade and close to the top of the terminal. Press the foot switch on the right foot to separate the clutch port. After the clutch is separated, the ultra-quiet terminal The machine drives the die and the blade to press down the wiring and the terminal, thereby completing the action;

8. Check whether the products in the upper process are qualified;

9. The tool is matched with the terminal. After proper adjustment, the following standards should be achieved.