Stripping and tapping machine use specification Stripping and punching terminal machine Stripping and punching terminal machine has a very high impact force, so care should be taken during operation. The correct operation of stripping the terminal machine is as follows:

 

1. Turn on the power switch of the terminal machine and the power indicator light is on.

 

2. Pay attention to whether there is any obvious abnormal sound inside and outside the machine. If there is a suspension operation, ask the mechanic to determine whether maintenance is required.

 

3. Selecting the knife and loading the knife: It is operated by the designated personnel. It is necessary to compare the technology with the selected blade before loading the knife. The tool can be loaded after the comparison is correct. After the tool is completed, it is necessary to use the hand test and first close the terminal machine. Power, press the touch button, use the special wrench to shake the main driven wheel, so that the stripping machine can reach the maximum stroke. If the hand is not moving, consider whether the pressure is too large or other problems, check and debug to OK. Before each operation, check the locking screws and acknowledge that there is no looseness.

 

4, loading: install the required terminal, use the hexagonal wrench to adjust the feeding plate, so that the terminal can easily pass, visually check whether the feeding position is suitable, if not, adjust, use the hexagonal wrench to loosen the feeder lock Tighten the screws and turn the conditioning mast to adjust to the best condition, then lock the feeder locking screw to start the operation.

 

5, test pull: After adjusting the machine OK, take the waste wire to test, carry out the pull test, the primary reference value see the "pull test comparison table" detailed operation method is as follows, press the pull test zero key to adjust to zero, will need to test The terminal wire is clamped and tested. If the measured tension is not within the specification, the mechanic should adjust from the beginning until the specification value is reached.

 

6, the trial production 10PCS to send IPQC for the first piece of recognition, check OK, in order to mass production, the operator in the production process is necessary to self-test the terminal is whether there is rubber, hanging neck and other bad, and once every hour Terminal pull test.

 

7. Finish the good and waste products after the production is completed, and clean up the environmental sanitation around the terminal.