There are many reasons why the opening is different. The most common one is that the wire reel is too tight or loose; in this case, you only need to use the roller fine adjustment to adjust the gap between the two wheels so that the wire is not flattened and too loose. If it is because the cutting knife is too shallow or too deep; then we use the cutter depth adjustment member to adjust the knife edge to the appropriate position, so as not to damage the copper wire and can peel off the rubber. If the opening is still different, replace the new cutting blade directly.

 

2, pressing the terminal exposed copper wire uneven:

 

Check whether the gun-type swing arm pipe is attached to the wire; whether the terminal machine edge is relatively straight with the swing arm pipe; whether the terminal machine auxiliary clamp is loose; check whether the distance between the terminal machine and the automatic machine changes.

 

3. The terminal machine cannot start running or stop during operation:

 

Can not start or stop during operation, first of all to check whether there is no current input and 6KG air pressure and there is a wireless material or a certain operating part stuck; also check the terminal machine for signal connection or power connection and lead to the terminal machine is not pressed .

 

4. The length of the electronic wire cutting of the terminal machine is inconsistent:

 

It may be the tangential edge wear or the knife edge; the problem with this is simply to replace the new cutter. The possible reason is because the wire reel is too tight or too loose; at this time we can use the roller fine adjustment to adjust the gap between the two wheels so that the wire is not flattened and too loose.

 

Some methods and techniques for dehumidification of fully automatic terminal machines

 

However, any electronic products of the fully automatic terminal machine will encounter some problems more or less during use. These problems are likely to affect the use of the machine and reduce the life of the machine. One of the most important and most common problems is "dehumidification", so how to dehumidify it. Summarize the following points and hope to help you!

 

1. Drain with air conditioner. Most of today’s air conditioners have this function. The dehumidification function of the air conditioner can be activated to effectively deal with the problem of humidification of the room during the rainy period, and the full-automatic terminal machine can also constitute an all-round maintenance.

 

2. When the factory’s fully automatic terminal machine is not in use, it is better to make a maintenance cover, which can effectively prevent the rear part of the appliance from contacting the humid air. At the same time, you can also improve the frequency of using these appliances, because the machine will generate heat when it is running, so that it can effectively dissipate moisture. If the computer can’t show up due to humidity, you can turn it on and the projector will be able to work again in about 10 minutes.

 

3, if the outside air is too humid, remember to close the door and close the window; if the house is too humid, to ensure the room ventilation, you can use air conditioning, fan to dehumidify.

 

4, if the wall is "sweat", it is recommended to purchase dehumidifier dehumidification. It is best to use an industrial dehumidifier

 

5. For long-term moist areas, it is possible to use charcoal in the room or bamboo charcoal under the indoor floor. The balance of humidity in the room and the prevention and control of dust mites and air purification have good effects. Ordinary factory buildings are best covered with cardboard boxes in the air.

 

6. Put some quicklime (mixed with sand) in the dead corners.