1. The length of the peeling opening is different: there are many reasons why the opening is different. The most common one is that the feeding wheel is too tight or loose; at this time, you only need to use the roller fine adjustment to adjust the gap between the two wheels so that the wire is not Squash and too loose. If it is because the cutting knife is too shallow or too deep; then we use the cutter depth adjustment member to adjust the knife edge to the appropriate position, so as not to damage the copper wire and can peel off the rubber. If the opening is still different, replace the new cutting blade directly.

 

 2. Unevenness of the exposed copper wire of the crimping terminal: Check whether the gun-type swing arm pipe is attached to the wire; whether the terminal machine blade is relatively straight with the swing arm pipe; whether the terminal machine auxiliary clamp is loose; check the terminal machine and the automatic machine There is no change in the distance between them.

 

 3. The terminal machine can’t start running or stop during operation: it can’t start or stop during operation. First of all, it must be checked whether there is no current input and 6KG air pressure and there is a wireless material or a running part stuck; also check whether the terminal machine has signal The connection or power connection leads to the terminal and the machine does not press.

 

 4. The length of the electronic wire cutting of the terminal machine is inconsistent: it may be the cutting edge of the cutting edge or the edge of the knife edge; the problem is simply to replace the new cutting knife. The possible reason is because the wire reel is too tight or too loose; at this time we can use the roller fine adjustment to adjust the gap between the two wheels so that the wire is not flattened and too loose.